1. Home
  2. WAVE OnCloud Gateway
  3. Capacity Plus Radio System Parameters
  1. Home
  2. Radio System Admin
  3. Capacity Plus Radio System Parameters

Capacity Plus Radio System Parameters

The following images map the WAVE OnCloud MNIS Gateway Connection Info parameter on the left with the radio system parameter on the right. Use these images to identify the values required when configuring the WAVE OnCloud gateway.

Master IP and Master UDP Port

Click Link Establishment in the CPS tool for your repeater or XPR.

Click Link Establishment in the CPS tool for your repeater or XPR.

MNIS Radio ID

The MNIS Radio ID is a unique ID that does not occur in the radio system. It is used to identify the WAVE OnCloud Gateway to the radio system as an LE (Link Establishment) peer. Radios and repeaters all of their own unique ID. The WAVE OnCloud Gateway cannot have an ID that overlaps with any of the IDs in the radio system.

In the MNIS Link Establishment UDP Port field, enter the UDP port that serves as the gateway to the LE (Link Establishment) domain. The WAVE OnCloud Gateway uses this port to send and receive audio and keepalive messages with the radio system.

CAI Network and CAI Group Network

Select Network in the CPS tool to view the Radio Network page for your repeater or XPR device.

DDMS Server IP Address and DDMS Watcher Port

In the DDMS Server IP Address field, enter the IP address of the radio system presence notifier. This is only required if NAI Data is enabled on the radio system. If your radio system does not use NAI Data, then enter 127.0.0.1 for the IP address.

In the DDMS Watch Port field, enter the receiving network port for the LCP/Cap Plus presence notifier. This is only required if NAI Data is enabled on the radio system. If your LCP/Cap Plus system does not use NAI Data, then leave this field blank.

To determine if you have NAI Voice, look in under Device Features in the code plug for your XPR or repeater and check the Status of Network Application Interface Voice to ensure it reads Purchased.

NOTE: NAI Voice is only required if your repeaters have not been upgraded to version R02.07.00.04 or newer. If you do not have NAI Voice or your repeaters are upgraded, then leave the values at default: Port 3000, IP Address 127.0.0.1.

Updated on May 23, 2018

Was this article helpful?

Related Articles

Add A Comment